You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

jenksb

New Member

1

Tuesday, March 30th 2004, 5:29am

Connecting fittings to poly

I have a question, I was told to use a hair dryer to soften the poly when putting fittings on as this helps mold the pieces together to cut down on leaks. Here's my question, can I apply heat carefully to the poly with my propane torch? Please any advice?

aquamatic

Advanced Member

Posts: 229

Location: USA

2

Tuesday, March 30th 2004, 6:21am

General rule is no!
But most contractors do- You need to just float the pipe about 2" away from the flame for about 3 seconds and thats it, just enough to provide a little warmth to the pipe. If you notice it turning glossy and melty, cut the tip and start over.

You can also lube with dish soap or KY jelly- this wont harm the plastics

jenksb

New Member

3

Tuesday, March 30th 2004, 12:23pm

Thanks Aquamatic...the torch worked great!! no leaks!!! Thanks again.

Rate this thread