You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

mihomeowner

Unregistered

1

Saturday, May 25th 2013, 3:50pm

PVB Assemly replacement

Also posted this on the backflow board, but this seems to be more active and hoping to get some help.


Hello,
I didn't shut the water off to my sprinkler system in time last winter and we got an early freeze and I got a crack in my PVB and one of the nearby pipes (the downstream pipe).

Anyway, I am racking my brain getting started. My setup looks almost exactly the same as this guys:
Conbraco 1" PVB (see pictures)

There is a crack in the PVB casing, so repairing the internals isn't going to work. Need to replace the entire thing. This is what I am thinking of ordering to replace it:

http://www.sprinklerwarehouse.com/Conbra…c4a-505-02f.htm

Which should work. My only problem is, how the heck do I get the old one off? I went out with some wrenches and thought it would be fairly easy but I can't figure out what to unscrew. Then I started researching, and have seen some people sawing off the piping which seems to be what I have to do.

There are two valves on the PVB. Does only one of these typically screw in, and the other needs to be welded on? If that is correct, does it matter which one gets threaded?

Slightly confused!!! Thanks for any help.

---
I fixed your link. Mrfixit..

This post has been edited 1 times, last edit by "mrfixit" (May 27th 2013, 1:02pm)


Central Irrigation

Supreme Member

Posts: 363

Location: Central Minnesota

2

Monday, May 27th 2013, 10:17am

Youll have to cut the down pipe. All joints on the assembly are threaded and will unscrew with a little muscle and the proper wrenches. Start unscrewing from the outlet side and work to the inlet side taking it apart piece by piece. Reassembly will start at tje inlet and work toward the outlet. If youre lucky enough to have enough room, you may be able to spin off the whole assembly at once. Use plenty of teflon tape and tighten well. Never loosen an overtightened joint, take tje time and redo it. You will need to solder the copper down pipe when all done, so dont forget the tools for that. Should take you about 20 minutes!

Similar threads

Rate this thread