Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.
Controller "Rid-O-Rust" Fault
My controller (800-PL) does not send out a 24VAC signal across the C (common?) and P terminals that will allow the Rid-O-Rust system to run when the sprinklers do. All other terminals have the required 24VAC voltage and the sprinklers run fine. Any idea what I should check/replace? It has worked fine for the last four years and has now stopped.
Correction: my controller is a PC300 (outdoor, 15zones)
I'm not real familliar with all of that controllers features but, I do believe it may have a master valve select. Meaning you can choose to turn on your master valve or not for every station. When I refer to the master valve I mean the pump (p) or master valve (mv )circuit. Go through your programming guide and see if it has a mv selection and switch it to the on position for the zones you wish to run your Rid-o-Rust system on.
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist
It does have a mv selection switch. If you don't have your instructions you can go to www.hunterindustries.com. Click on products, then controllers, then on the Pro-c, then click on the installation and programming link.Then scroll down, It will be under the advanced features #8.
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist
SPRINKLER TALK FORUM - You Got Questions, We've Got Answers »
Help with Troubleshooting / Service / Repair »
Controllers, Sensors, & Remotes »
