You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

TJS

New Member

1

Thursday, May 21st 2015, 12:55am

Is it a pain to jump other lines with a vibratory plow?

My design has a lot of lines that have to cross over a line from a different zone. It's been a while, but I seem to remember when using a vibratory plow you can adjust the depth on the fly right? So when I'm crossing a line, I can raise it up a few inches to miss something and then go back to standard depth.
Does that sound right? The other option is run a boat load more pipe to get around. More friction more pipe and more cost.

Wet_Boots

Supreme Member

Posts: 5,288

Location: Metro NYC

2

Thursday, May 21st 2015, 7:15am

For the money, you don't cross lines. Extra pipe is cheaper than the possibility of damaging lines during a crossover.

Rate this thread