You are not logged in.


Advanced Member


Sunday, June 24th 2007, 5:45pm


i have atleast one of my spray zones getting clogged with some kind of stuff i have never seen before its clogging my spray filters to the point they will not spray anymore and have to be cleaned out.i can wash them out or use air and blow them out and re-install them and they will get clogged again in a matter of days. pulled all of them and cleaned them and ran that zones for maybe 10min to get the lines cleaned and they still get clogged its like a white sringy stuff.i have never had this problem until after i installed a that the problem?any ideas how to cure the problem.i have turn my fertigator off for serval weeks before this was a problem but now it is...i turned the fertigator off b/c of a fungice problem never had the problem until after i turned it you think it left some kinda of film in the lines?


Advanced Member

Posts: 158

Location: FT. Walton Beach, Florida


Monday, June 25th 2007, 2:34am

Without being able to see what you are describing, my guess would be on the Fertigator.
Irrigation /Landscape Lighting / Pump and Well Specialist


Advanced Member


Monday, June 25th 2007, 12:55pm

its almost like some kind of slim or snot...

Fertigation Guru

Active Member

Posts: 39

Location: USA


Wednesday, June 27th 2007, 3:00pm

The “white stringy slime” you are seeing is actually the secretion from a sulfur feeding bacterium. The sulfur in your fertilizer is providing sustenance for the bacterium which is producing the slime. Unfortunately sulfur is necessary in fertilizer to counteract the alkalinity of salts. However, I am not sure of the exact sulfur content in Fertigators fertilizers, but their has to be some. If you discontinued the use of the Fertigator for an extended period of time, the problem would disappear assuming there is no other sulfur source.

There are two treatments. The one you use depends on the water source for your irrigation system.

Well water- you have to treat the well itself because this is where the bacterium is originating. The bacterium has been in your well for quite some time, and the Fertigator just allowed it to become visible. The solution to the problem is chlorine. You can shock the system, very similar to a shock treatment of a pool. The chlorine will kill the bacteria and inhibit future growth. Sulfur feeding bacteria is very resistant to chlorine because of the thick layers of slime (white stringy stuff). The secretion is what protects the bacteria. A standard treatment may kill off the bacteria on the surface layers of the slime but will leave the inner layers unaffected and free to continue multiplying. I would strongly consider consulting a well specialist to perform the service for you. It may require multiple chlorine treatments before the problem is controlled.

City water- it is rare that city water will carry this bacterium due to the high levels of chlorine injected at the water treatment plant. However, if this is the case, it is more difficult to fix. You will need to introduce chlorine into your irrigation lines on a periodic basis. If the bacteria only exists in your irrigation lines it will eventually go away completely after multiple treatments. The hard part is introducing the chlorine into your irrigation line. Do not worry it can be done, but I can provide instructions if you need me to. My feeling is you are using a well...

Rate this thread