You are not logged in.

guill34

New Member

Posts: 2

Location: USA

1

Monday, June 4th 2007, 6:49am

toro controller greenkeeper 212

my system will go thru the cycle & state up again and then another time. i have cleared the memory, that did not work. i disconnected the power for 30 minutes, and still the same. i think this should take care of the double program times. i tried the steps in the toro manual, nothing.

mrfixit

Moderator

Posts: 1,457

Location: USA

2

Monday, June 4th 2007, 11:19am

I have a couple of items for you. Number one is there a 9 volt back up battery in the timer and did you take it out while it was unplugged? That battery will remember the programming for days if not weeks. I was also wondering if the same person programmed the timer after you erased it's memory. Maybe you made the same mistake in programming again. There are start times and there are station run times. You only need one start time to run all your valves. The run times are for how long each individual valve will run. Also look at all the programs. A-B-C. Maybe you've double programmed it. Only use the A unless there's a part of your yard on a special watering schedule.
If I can't fix it, it's broken!

guill34

New Member

Posts: 2

Location: USA

3

Monday, June 4th 2007, 1:11pm

thank you very much!

i did not know that i only needed 1 start time. i have 3 valves & set 3 different times. i've changed this.

thanks again....

Rate this thread