You are not logged in.

ejzajac

Senior Member

1

Monday, February 21st 2005, 9:06am

irritrol valve

I'm planning on usinf irritrol 2400 control valves on the next project. Do most installers use the threaded or the slip style? Is "flow control" of value?

Wet_Boots

Supreme Member

Posts: 4,020

Location: Metro NYC

2

Saturday, March 19th 2005, 4:57pm

In a warm climate, where you don't need to 'winterize' a sprinkler system, because of freezing water, all the piping, along with the valves, would be slip style, for speed of assembly. Flow controls on 2400's are a screwdriver-adjusted type. Not as handy as a handwheel type of flow control. They aren't essential.

nestors

Advanced Member

Posts: 110

Location: USA

3

Thursday, April 7th 2005, 9:17am

slip is easier ,if you have problems down the road you still have to cut it out .
Vincent Nestor
Nestor's Sprinklers & Lighting
Alpharetta,Ga.30022



vpn1@bellsouth.net

www.NestorsLandScape.com
www.GeorgiaLighting.net

RidgeRun05

Supreme Member

Posts: 314

Location: USA

4

Thursday, April 7th 2005, 7:55pm

Slip style is the way to go, faster installation and far less likely to cause problems such as leaks than the threaded valves...down the road. If you are going to use poly pipe for the lateral lines, they make valves with the barb fittings as well.
Tony Posey
Ridge Run Landscapes

Rate this thread