You are not logged in.


New Member


Tuesday, March 30th 2004, 5:29am

Connecting fittings to poly

I have a question, I was told to use a hair dryer to soften the poly when putting fittings on as this helps mold the pieces together to cut down on leaks. Here's my question, can I apply heat carefully to the poly with my propane torch? Please any advice?


Advanced Member

Posts: 229

Location: USA


Tuesday, March 30th 2004, 6:21am

General rule is no!
But most contractors do- You need to just float the pipe about 2" away from the flame for about 3 seconds and thats it, just enough to provide a little warmth to the pipe. If you notice it turning glossy and melty, cut the tip and start over.

You can also lube with dish soap or KY jelly- this wont harm the plastics


New Member


Tuesday, March 30th 2004, 12:23pm

Thanks Aquamatic...the torch worked great!! no leaks!!! Thanks again.

Rate this thread