You are not logged in.


Starting Member


Thursday, July 28th 2016, 7:12pm

Imperial 1"Brass Valve Solenoids

Does ANYONE have a solution, other than rebuilding the entire valve manifold for finding solenoids for these outdated valves? They have faithfully worked since 1994 but each solenoid is starting to fail and sending error faults to the brand new Hunter controller. I am pretty experienced at this game but I cannot seem to find and easy solution of simply pulling off the solenoid and replacing it. Thoughts???

Overheated in Salt Lake City......


Supreme Member

Posts: 480

Location: Houston, Texas


Thursday, July 28th 2016, 8:35pm

I will open it up.
The New controller is having an issue with the ground on the older brass valves.

You will Probably need to find a controller that is not so sensitive that it will create error messages from the Grounding.

I am sure that others can help with controller models that won't trip a false error.

The Valves may not be failing if the only indication is an error at the controller.

What was the older controller make and model?

That is what is happening.

Good Luck
:thumbup: :thumbsup:
LI0006121, BPAT0011021, CI0009500


Supreme Member

Posts: 5,177

Location: Metro NYC


Thursday, July 28th 2016, 8:39pm

It is not the solenoids failing. It is a solid state controller mis-identifying the high current draw as a short circuit.

You need a bank of relays and a separate 24 VAC transformer to power those valves, in order to have zero issues with the controller.

One 24VAC relay for each zone, plus one for a master valve. Controller switches the relays, relays switch the solenoids. At no time is there any actual electrical connection between the valves and the controller, because the relays isolate them from each other.

Rate this thread