You are not logged in.

aquamatic

Advanced Member

Posts: 230

Location: USA

11

Tuesday, September 23rd 2003, 10:12am

To pop it without the tool. Just remove from the housing and lay it on a flat surface standing up. Gently grasp on the threaded grooved cap that goes around the head and pull down.

Unscrew the adjust screw up enough to remove the nozzle and check to see if its clogged.

If you need to replace you can order the same head from SW, you will get the entire head with housing. I wouldnt recommend messing around with wiper seals and bottom seals. The heads are affordable enough to just replace the insert unit

Rate this thread