You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

jbson47

Unregistered

1

Saturday, June 29th 2013, 8:20pm

Low pressure and water comes from all zones

I am in Michigan and my sprinkler systems runs off of a well with a submersible pump. Last summer my sprinklers started to lose pressure. After a few weeks they wouldn't even pop up any more. It was extremely hot all summer and we had no rain. My first assumption was the well had dried up. This spring when I tried to fire it up, the pressure was still low, and when I turned on a zone, water also came out of the heads in other zones.

After receiving much advice, the first thing we tried was removing the pump and soaking in vinegar. Didn't help.

With some help we found the timer was shot and was telling the pump to run ALL of the time unless the breaker is off.
Replaced the timer and now the pump runs appropriately, but all the zones still run at once with low pressure.

My thought is that the pump has been running nonstop since last summer, including all winter. Water froze and messed up valves, causing the current situation. Is this reasonable or is there a more likely problem? What should my next step be?
Thanks!

Wet_Boots

Supreme Member

Posts: 4,078

Location: Metro NYC

2

Saturday, June 29th 2013, 9:50pm

throttle down the flow controls on your zone valves - if they don't have flow controls, you should install new zone valves that do have flow controls

mrfixit

Moderator

Posts: 1,460

Location: USA

3

Saturday, June 29th 2013, 9:51pm

Try closing all but one of the valves with the flow controls. Then turn the open valve on with the controller. Is it working?
Now with that valve still operating open each flow control one at a time. Wait for each valve to shut off before opening the next flow control.
Eventually all the valves but the operating one will shut off if everything else is operating normally.
Don't leave the flow controls fully opened. Turn them down a bit.

Rate this thread