You are not logged in.

joe13

New Member

1

Wednesday, October 3rd 2012, 3:51pm

Hunter pro-c controller problem

my house took a lighting strike and caused my system to stop working. I replaced the face plate and now the system sporadically recognizes all the zones and sometimes it does not. I have 3 modules inside and I beleive two control 3 zones each and then a larger one that controls 9 zones. It seems that the the module at the bottom works all of the time with the exception of zone 3, and then the second module works all or nothing and the same for the larger module, except it appears that zone 9 and 15 do not work at all. all the sones show up on the faceplate when I program it and they show taht they are working when I run each zone in the manual mode, but no water.
so my question is what do I need to check, test or replace? modules, inner workings, ????
Thanks....Joe

hi.todd

Supreme Member

Posts: 417

Location: Houston, Texas

2

Wednesday, October 3rd 2012, 6:28pm

Unplug the clock.

Unlock the modules

Pull out all modules

Reinsert all modules.

Lock all Modules.

Plug in.

Try to activate the clock.
:thumbup: :thumbsup:

Wet_Boots

Supreme Member

Posts: 4,081

Location: Metro NYC

3

Wednesday, October 3rd 2012, 7:23pm

have a beer

order new controller :thumbup:

Rate this thread