You are not logged in.


Starting Member


Monday, September 3rd 2012, 4:13pm

Toro Greenkeeper 212

Just replaced the control module with a brand new one - same model. The new model shipped showing only 4 zones. I have 12. I added 2 modules connectors to the system and connected all 12 wires from each of the 12 zones (Exactly how they were connected to the old controller). Problem- the controller will not recognize zones 5-12. I cleared the controller memory so I could set each zone run times but it still only shows 4 active zones on the LCD. Anyone had this problem ?



Posts: 1,744

Location: USA


Monday, September 3rd 2012, 9:09pm

Try removing all the modules. Unplug the controller. Take out the back up battery. Replace the modules. Plug the controller back in.
Ok I read your post again, each zone doesn't have it's own start time. You only need ONE start time then the 12 zones will run in sequence.

Rate this thread