You are not logged in.

lkt1947

Starting Member

1

Wednesday, August 29th 2012, 4:00pm

Hunter Pro C Irrigation Controller all programmed but will not activate as programmed

We had a couple of power surges recently and then a power outage for about 3 hours one day. I had to re-program the Controller after each surge and it worked however, after the power outage it took reprogramming but does not run automatically. The statement that it would hold memory apparently is not true at least for my controller. ;(



I have done the Hunter quick check and saw no ERR symbols on the 11 stations. I then tried the Hunter Easy Retrieve Program Memory and neither would it save the current program or retreive the previous program.



Any suggestions will be appreciated.

mrfixit

Moderator

Posts: 1,462

Location: USA

2

Wednesday, August 29th 2012, 6:11pm

Have you reset the controller?
There might be directions on the back of the faceplate on how to do it.
Or check the manual.
This will reset the controller to the factory program.
-
Maybe that's what you meant by retrieve program memory.

Rate this thread