You are not logged in.


New Member

Posts: 2

Location: Albany NY


Thursday, June 21st 2012, 2:23pm


I just installed a SolarSync sensor to a Hunter PCC1200i controller and I get a Err message in the display. What would cause that? There is nothing in the manual about this and I followed the directions to a tee.


Thursday, June 21st 2012, 3:03pm

Controller shows “ERR” in display • Module wires not properly
connected to controller terminal. Check the connection between module and controller and
compare to wiring diagram in System Installation section of Owner’s Manual

Solar Sync module shows “ERR” • Connection between module and
sensor faulty
Check connection

If connections good check from stripped insulation.

Rate this thread