You are not logged in.

jfralph

Unregistered

1

Tuesday, May 15th 2012, 2:48pm

Hunter PGV valve not opening after cleaning

I have a PGV valves in my 6yr old system. This spring, upon start-up, several zones began to bleed past the valve. I first tried to pull off the solenoids and open the bleed screws to flush the valves, however, the problem persisted. I then pull the valves apart and cleaned the valve, but still had valve leakage. As a last resort, (lawn was drying up) I purchased new valves and pirated the diaphram from the new valves. Everything worked for short period, however, some additional dirt got into 2 of the valves, and I again took the valves apart and cleaned out a single grain of sand. When i reassembled the valves, the zones will not pressure up. All other zones work fine, But the two zones I recleaned, will not allow pressure through. They are in different valve boxes and on different wiring. One zone by using the bleed screw, I can get normal pressure. On the other zone, I get enough pressure to pop sprinklers up, but only enough to spray half their area.



Any ideas/suggestions?

Wet_Boots

Supreme Member

Posts: 4,027

Location: Metro NYC

2

Tuesday, May 15th 2012, 3:22pm

You may still have dirt in the valves, in the narrow passages beneath the solenoids or in the valve bonnets.

3

Tuesday, May 15th 2012, 4:22pm

Sure sounds like dirt in the extremely small opening under the solenoid.

seansy59

Advanced Member

Posts: 97

Location: NJ, USA

4

Sunday, May 20th 2012, 10:28am

Moving parts do wear out. It may be time to replace the diaphragm.
I'm no expert..........YET! :D I just like to suggest things and learn... :thumbsup: See what the pro's have to say first.

Rate this thread