You are not logged in.

MP1975

New Member

1

Saturday, May 12th 2012, 10:55am

Zone 3 heads do not pop fully up.

The sprinkler heads in zone 3 do not pop fully up like my other 2 zones. "Assuming" since they are coming from the same water feed the pressure is strong enough and ensuring none of the heads are leaking etc etc kind of puzzled. I also checked the on / off manual setting on the control valve to make sure it was fully on , which it is.

Thanks again for the help.

Wet_Boots

Supreme Member

Posts: 4,080

Location: Metro NYC

2

Saturday, May 12th 2012, 11:41am

Look for leaks - if none are evident, you need a pressure gauge to diagnose further.

MP1975

New Member

3

Saturday, May 12th 2012, 1:45pm

Will do TYVM.

MP1975

New Member

4

Monday, May 14th 2012, 12:07pm

I ended up digging the first two heads and piping to check for leaks "thinking" it seemed damper then the rest of the yard. I figured that where the leak was....none was found. I disconnected the heads, cleaned them, put the heads back on and the pressure is much better. The heads raise about 3/4 of the way. So to be honest not 100% sure what the cause was but something did help.

TYVM for the response.

mrfixit

Moderator

Posts: 1,474

Location: USA

5

Monday, May 14th 2012, 9:32pm

Turn the valve on with the bleeder screw. Did that help?

Rate this thread