You are not logged in.

Lolly

Starting Member

1

Friday, July 22nd 2011, 11:50am

Hunter System will work on manual but not on program

What am I doing wrong read manual and followed all steps

Mitchgo

Supreme Member

Posts: 502

Location: Seattle

2

Friday, July 22nd 2011, 12:54pm

Read them again?

Stick with 1 program ( A) , 1 start time, Days you want to water, and zone run times on all the zones you have

Matt Dildy

Senior Member

Posts: 17

Location: Fort Worth TX

3

Tuesday, July 26th 2011, 2:08pm

to add to what mitchgo said i would program a "mock" start time to double check controller function before walking away and assuming all is well

example:

set program A start time #2 for a start just a few minutes from whatever time the controller has (so if its 12:45pm set a start at 1:00pm). make sure whatever day it is you have turned that day on. now sit back and wait, at 1:00pm zone #1 should kick on. turn controller off before it cycles all the way though, we just wanted to see it start. dont forget to erase that "mock" start time.



99% percent of the time these programmed "non-starts" are a programing error of one sort or another, typically if a controller will manual correctly it will run in automatic correctly, with a few exceptions.

Rate this thread