Hunter Pro-C Err

carverrocksred

Starting Member

Posts: 1

Monday, July 4th 2011, 3:47pm

Hunter Pro-C Err

Our Hunter Pro-C system was running fine for weeks and one day it didn't run at it's normal program. I went to check the controller and it read, "5 Err". Tried running single stations manually and each station came back with "1 Err", "2 Err", etc. Called Hunter...they thought it was the cellinoid. So I bypassed zone 5's cellinoid and no luck. Called the people who installed our system and a guy came out and didn't have a clue either. Anyone experienced this error message?

Go to the top of the page
Quote

Mitchgo

Supreme Member

Posts: 502

Location: Seattle

Monday, July 4th 2011, 6:01pm

Reset the controller

Ohm resistance to each valve and voltage readings need to be taken from a multimeter to be able to diagnose the issue

Go to the top of the page
Quote

servicetechMA

Advanced Member

Posts: 63

Friday, July 8th 2011, 7:13pm

pro c

try holding down the prg - and right arrow,then hit reset on back of faceplate,continue holding the three buttons until 12 am is displayed on screen. this might fix it,this periodically happens. not saying this will fix it,but it could,if it doesnt you need to get a competent service tech out there lol, but not before you do what mitchgo says,that needs to be done to find the problem. do any zones work manually from clock.

Go to the top of the page
Quote

Similar threads

- Controllers, Sensors, & Remotes »
- OP Err and IP Err on Pro-C controller (Aug 29th 2010, 10:02am)
- Controllers, Sensors, & Remotes »
- Err Codes on Pro-C (Aug 5th 2010, 10:55am)
- Not Sure What's Wrong? »
- Zones 2,3,&4 shows "Err" when set to Run Single Station on a Hunter Controller. (Apr 28th 2010, 6:28am)
- Valves & Wiring »
- 1 err, 2 err, 3 err, on a Hunter Pro-C (Apr 14th 2008, 5:55pm)
- Controllers »
- 12 zone controller replacement (Apr 16th 2006, 1:07pm)