You are not logged in.

Loralee_d

Unregistered

1

Wednesday, April 20th 2011, 9:51am

Same Zone comes on everytime

Have a rainbird with 6 zones....no matter which zone I attempt to run, only zone 1 comes on everytime..any ideas??

Wet_Boots

Supreme Member

Posts: 4,064

Location: Metro NYC

2

Wednesday, April 20th 2011, 12:12pm

Valve is stuck open, or manually opened.

mrfixit

Moderator

Posts: 1,469

Location: USA

3

Wednesday, April 20th 2011, 12:42pm

I have a couple of questions for you.

You say no matter which station you try to turn on station 1 comes on. What does it say in the display?

Does it say station 1 or does it show the station you're trying to turn on?

I've seen a few RainDial controllers turn on station number 1 no matter which station you're trying to turn on manually but it says station 1 in the window. Never seen any other model controller do it.

Do you have a master valve?

Loralee_d

Unregistered

4

Wednesday, April 20th 2011, 4:28pm

The displat will show zone 2, 3, etc....but only zone 1 comes on.

Mitchgo

Supreme Member

Posts: 499

Location: Seattle

5

Wednesday, April 20th 2011, 11:31pm

Is your controller a RainBird Esp 6 SI ?

You can't switch the dial to a particular zone and press manually start.

You have to cycle through the zones.

While in the Auto position ( As long as the zone has minutes ) You must press the Manual Start/ Advance button, wait a second and press it again, continue this to get to your desired zone.

mrfixit

Moderator

Posts: 1,469

Location: USA

6

Thursday, April 21st 2011, 3:54pm

It could be a variety of issues.

Try disconnecting the wire from the number one terminal then turning on a zone. Does it still come on? If yes you've ruled out the controller.

Do you have a master valve? As boots stated there might be something wrong with the number one valve and the ground wire is disconnected to all the valves but the master valve.

Could be the wiring's messed up. Meaning it's not hooked up right or damaged. You'll have to fiddle with it to figure it.

Is the number one wire in the right slot? Maybe it's hooked up to the master valve/pump terminal?

Rate this thread