You are not logged in.

5IVE

Starting Member

1

Thursday, April 7th 2011, 4:37pm

Zone will not come on

I have a zone that will not come on at all it's zone #4. any answers.

mrfixit

Moderator

Posts: 1,474

Location: USA

2

Friday, April 8th 2011, 11:38am

Is the controller putting out power to valve 4?

Is the valve receiving power from the controller?

Is there water at the valve? Open the bleeder screw if there is one.

Is the flow control turned off?

If you haven't found the problem yet then the valve needs repair or replaced.

Mitchgo

Supreme Member

Posts: 499

Location: Seattle

3

Sunday, April 10th 2011, 2:39am

You have much more patients then me :D

hi.todd

Supreme Member

Posts: 412

Location: Houston, Texas

4

Sunday, April 10th 2011, 1:20pm

Mitchgo short on patients the other day I noticed. The duct tape and all.

It is hot out there. Time for some Iced Tea.

Lets all have a good week.

:thumbup: :thumbup: :thumbup: :thumbup:
:thumbup: :thumbsup:

Mitchgo

Supreme Member

Posts: 499

Location: Seattle

5

Sunday, April 10th 2011, 2:06pm

I simply just don't understand how someone can come onto a forum and ask the most generic vague question about a specific problem..This is for all forums too, I mean if they were smart enough to find the forum, couldn't they have had done a little bit of research first? Or at least explain it in detail

Mitchgo

Supreme Member

Posts: 499

Location: Seattle

6

Sunday, April 10th 2011, 2:08pm

My response to the op ....

Is the controller plugged in?


don't mean to be a jerk, but stupid questions get stupid answers

Rate this thread