You are not logged in.

1

Tuesday, May 18th 2010, 1:39pm

RD-600 AND CHATTERING VALVES

I'm helping a neighbor with an Irritrol RD-600. The problem is that the solenoids chatter when turned on.
I disconnected all zones from the RD-600 panel and connected a Solenoid directly to the panel.
When that solenoid is turned on, it will make a screwdriver chatter when put close to it.
I checked the input voltage and found it to be 27 VAC. on a digital meter.
I checked the voltage across the solenoid I had connected to the panel and don't get a constant AC voltage. It jumps around from 5 to 14 VAC. If I check DC, it also jumps around.

It seems to me that the controller is chopping the output to the solenoid. It's neither DC or AC coming out. (If I had an oscilloscope, I would know exactly what it looks like)

All zones behave the same.
Tried two different (new) solenoids right at the panel and get the same result.

I opened up the RD-600 to see if there was any evidence of smoked parts or anything obvious.....nothing.

Anybody have any Ideas?

Wet_Boots

Supreme Member

Posts: 3,876

Location: Metro NYC

2

Wednesday, May 19th 2010, 9:39pm

try connecting a solenoid directly to the transformer and completely bypass the controller.

3

Saturday, May 29th 2010, 11:58am

Bad Capacitor on Controller

My neighbor took his RD-600 to a shop and they found replaced a bad cap on the controller board.
All is good now.

Rate this thread