You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2530 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Thursday, July 21st 2011, 11:50pm

by riceling

Sounds good, thanks Wet_Boots.

Thursday, July 21st 2011, 9:32am

by Wet_Boots

just go to the nearest pipe

Thursday, July 21st 2011, 3:26am

by riceling

Where to tap into an existing system - Advice on a project


I’m working on adding a new section of sprinkler line to an existing system. The new line goes between a wall and a concrete patio. I’m wondering where the best place is to attach it to the existing system.

There is existing line in the bark-covered gardens within 5 ft of the location I wish to put the new line, but neither provides a direct route. There may be a main line in the lawn that would be more directly accessible, but I have not dug into the lawn to look for it.

The proposed new line starts at the dashed red circle. Possible attachments locations are at the solid green circles.

Any advice and insight would be greatly appreciated!