You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4113 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Saturday, October 13th 2007, 3:28pm

by nestors

Nelson can be very confusing,I would replace it with a Hunter pro-c timer,rain sensor compatible with a bypass and remote control capabilities,also expandable to 12 plus zones.

It is better to be sure that your sytstem runs correctly with a new timer.


Vincent P. Nestor
Nestor Enterprises,Inc.
9945 Buice Rd.
Alpharetta,Ga. 30022
770/410-9356 ph.
770/410-9609 fax

Thursday, September 6th 2007, 2:36am

by Wet_Boots

There might be other programs active. You might be looking at program A, and there could be a program B or C doing some watering. Have you read the controller manual?

Wednesday, September 5th 2007, 4:52am

by rjhuss

My program does have two start times, 7:00am and 7:00pm. But the controller runs each zone twice at each time.

Tuesday, September 4th 2007, 1:58pm

by gregory1420

i don't think there is something wrong with icc controller has program A but i can have program A run twice a night if i want...look to see if your program has more then one start time....

Tuesday, September 4th 2007, 12:46pm

by rjhuss

Trouble with Nelson Smartzone EZ

I just recently moved into a new home that has a complete Nelson system installed. I have never used Nelson equipment and have a question with my controller.

It seems like my program always runs two times each cycle, Is this normal?

Example, 6 zones x 10min each. When I set it to run this program at 7:00am, it will do the following.

I have erased the entire program and started over with the same result.

Do you think there is something wrong with this controller???