You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2626 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 10 posts

Thursday, May 17th 2007, 7:16pm

by lush96

your around nyc wet. im on the island. maybe we should meet and discuss sprinklers furthur.

Thursday, May 17th 2007, 2:45am

by Wet_Boots

I prefer to replace a backflow that's been frozen. I don't have a lot of faith that the brass survives the experience without any warping. I don't know whether the Febcos have any problems passing testing, if they've been repaired after a freeze-up. Actual testing requirements haven't yet been legislated by the states around my neck of the woods (NYC) ~ I have a Watts TK-9 at the ready, but it's all dressed up and nowhere to go.

I do tend to look at a PVB in terms of its primary function of a 24/7 vacuum breaker. I don't use the Febco 765, because of the plastic bonnet, which makes it too fragile. A few older designs have brass bonnets, and I've chosen them. If I was looking at a PVB in terms of its pass/fail performance in check valve testing, a different picture might emerge.

Wednesday, May 16th 2007, 6:45pm

by tehachapibackflow

WET BOOTS DO YOU TEST BACKFLOW ASSEMBLIES OR REPAIR THEM?

Tuesday, May 15th 2007, 3:44pm

by Wet_Boots

If you winterize it properly, you can live with the Febco. Any PVB will not survive a winter with it filled with water.

Tuesday, May 15th 2007, 3:34pm

by wonkanator

Do you have a suggestion of something better I could purchase to replace the Febco 765-1? I was only going to replace it with another one because that is what is there already. If there is something better I should get I would love to get your input.

Tuesday, May 15th 2007, 2:59pm

by tehachapibackflow

To all who actually test and repair backflow assemblies you should know by now that anything with the name "febco" is nothing better that a 8 lb. brass paper weight. Lets all do eachother a foavor and never install or replace a febco piece of junk again.

Tuesday, May 15th 2007, 2:31pm

by wonkanator

Thanks Tom. I have a Febco 765-1 that needs a few parts replaced and I found out that it is cheaper to just buy a whole new PVB rather then get the parts replaced. I found the 765-100 for a decent price and I just wanted to confirm that it was the same as what I currently have. Thanks again.

Tuesday, May 15th 2007, 1:57pm

by Tom

yes

Tuesday, May 15th 2007, 1:09pm

by wonkanator

This might sound stupid, but is the 765-1 the same as the 765-100 PVB?

Sunday, May 13th 2007, 3:36pm

by Wet_Boots

Cut the pipe(s)