You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Friday, July 27th 2018, 7:25am

by Wet_Boots
You are probably looking at Zinc Oxide. The temperatures for casting brass are fairly close to the melting point of zinc, so a bit of zinc might migrate to the surface of the cast part, where it can later oxidize. Do not worry about it.

And do not paint the backflow preventer.

Thursday, July 26th 2018, 7:08pm

by Eric1116 (Guest)

Is this backflow really brand new?

One contractor sold us this stuff for $505 and claimed it’s brand new, I feel a little bit skeptical.... why it’s powdered white in the middle, not like what I saw on amazon all brass? any idea? Thanks.


Friday, May 25th 2018, 11:49pm

by RichMoney

Most likely what happened is some trash got into the line and contaminated the backflow, in which case it starts to dump water.

You can open up the backflow and see if anything is obstructing the plunger. When you put it back together try closing the discharge side of the backflow then open the inlit side of the backflow as soon as possible this will allow the water to seal the plunger as quickly as possible.

Sunday, May 20th 2018, 8:31am

by (Guest)

backflow preventer gushing water from the bottom


I have a well to supply my sprinkler and drinking water. This system has a back flow preventor, watts 3/4" 009M3-QT, and is gushing water whenever the sprinkler system is off.

The gushing of water started happening after replacing the 3/4hp well pump with a constant pressure system that maintains 70psi. I tried using pressure reducing valve but it didn't work.

Is there another type of backflow preventer I should be using? or is there something that need to be added to my sprinkler sprinkler system to reduce the higher pressure?

Thank you