You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 452 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, September 19th 2017, 1:56pm

by delivery

Thanks @All Wet Irrigation Seems this will do the trick!

Tuesday, September 19th 2017, 12:08pm

by Wet_Boots

Why exactly 1 bar? What is achieved by holding that pressure, and nothing higher, in your tank? It would make more sense to have higher pressure in the tank, with simple conventional pressure switch controls, and to reduce the output pressure by way of a pressure reducing valve.

Tuesday, September 19th 2017, 8:39am

by All Wet Irrigation

Baseboard Heat Pressure Reducing Valve

I'm not sure if this will help but baseboard heating systems use pressure reducing valves that automatically refill the system when the pressure gets too low. Here is a link for one that goes from 10-25PSI. Best of Luck.
http://www.supplyhouse.com/Watts-0386450-S1156F-1-2-Union-Solder-Iron-Pressure-Regulator-3572000-p

Monday, September 18th 2017, 1:17pm

by delivery

Auto-Fill valve based on PSI

Is there a valve out there that will allow the flow of water based on the PSI?

I have a water tank where I need the PSI to always be at 1 bar(14.5 PSI) and to fill the tank when the PSI goes below 14.5.

I haven't been able to find a solution for this anywhere.

Any ideas?