You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 903 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Monday, October 31st 2016, 8:50pm

by chuggy1969

That manifold comes apart i would disassemble it and duct tape the pipes. Not absolutely necessary but it would only take 5 minutes, and thats really what your trying to protect from winter.

Thursday, October 27th 2016, 6:47pm

by Nicolas (Guest)

Yes I've been informed that this system is quite bad... I hacked up an adaptor to plug in the compressor on the end of the manifold to purge it. I will have to work on it when spring comes I guess...

Thursday, October 27th 2016, 4:10pm

by Wet_Boots

Your task ahead depends on how willing you are to work with the flexible white tubing. It (PEX tubing) is a material that the tools for working with are very expensive. This expense can be gotten around by using special 'convenience' fittings like those with the Sharkbite name. The reason for all this is that PEX tubing cannot be used outdoors above ground. It lacks the ability to tolerate UV rays from sunlight. You transition from PEX to copper and run that through the wall to the outside, and if you are on flat ground, run the pipe up to a Pressure Vacuum Breaker, located a foot-and a half higher than the highest sprinkler head in your system.

Thursday, October 27th 2016, 12:46pm

by Nicolas (Guest)

Thursday, October 27th 2016, 12:26pm

by Nicolas (Guest)

I'm in Montreal, Canada.
Would you like pictures of the pipes inside?

Thursday, October 27th 2016, 12:19pm

by Wet_Boots

Now there's a basket of deplorables.

You got a bit of work in front of you.

What you need to do is to start from the inside work from there.

Where is your location? Backflow prevention can be location-specific.

Thursday, October 27th 2016, 11:56am

by Nicolas (Guest)

Help winterizing system

This year for the first time I was tasked to winterize my house's irrigation system. Knowing close to nothing about it, I spent the last few days doing some research about how to do the job. Oddly enough, I couldn't find a single system identical to mine, or even similar. It seems that I have no valve to plug in the air compressor and that there is no backflow preventer, just a shut-off valve in the basement.
Is there an adapter I could plug in the pipe in the upper right on the first picture maybe? If not, what do you guys suggest?
Thank you (and sorry if these things are supposed to be basic knowledge...)