You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1768 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, August 17th 2013, 12:51pm

by mrfixit

You can just change the solenoid if that's the problem.
Try disconnecting one of the wires from the solenoid in question and turn that zone on again with the controller.
Do you still get the fuse warning? If not it's the solenoid. If so the wiring has a short on that zone.

Saturday, August 17th 2013, 9:51am

by Greenjeans (Guest)

Sprinkler System problem

Sprinkler control box signals "Fuse" when one of the stations turns on. This one station shuts the entire system down. I have shut that station off and the rest of the stations run fine. I suspect a bad solenoid, but I'm not sure. Can I replace just the solenoid or do I have to replace the entire unit?