You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 380 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, August 5th 2013, 3:25pm

by Wet_Boots

No bleed screw - manually operate them with a partial turn of the solenoid in a counter-clockwise direction.

I have successfully replaced Nelson solenoids with Irritrol solenoids.

Monday, August 5th 2013, 9:42am

by rcw (Guest)

Nelson Valve Not Turning On

I have two Nelson valves that will not turn on. I have tested the wires and it is receiving a signal. I can't seem to find where the bleed screw is located or how to manually turn on the valves?

The controller is a Nelson SmartZone E-Z.

Thank you.