You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 630 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, August 4th 2013, 10:53pm

by Wet_Boots

What are the flow rates of the existing zones? Once you have that number, you can try it on a pressure loss table. With well water, however, you can lose the ability to undersize a distant zone, because of pump and pressure switch concerns. You would likely pick a pipe size from the pressure loss chart that would lose only a fraction of 1 psi per hundred feet. That would eliminate any worries about the distant zone not having enough pressure, or its not being compatible with the existing pump control settings.

Sunday, August 4th 2013, 7:46pm

by Central Irrigation

depends on how much water youre trying to pass through it. Figure out the gpm of the zone and check back when you have that info.

Thursday, August 1st 2013, 1:53pm

by mikemd

Maximum length of 1" poly pipe run for zone

I want to make another zone and the run is on the far side of the house down the driveway. I would say it will be 200' before the first head and then approx 150' down the driveway with the rest of the heads. Is there a max length I will be exceeding in doing this due to lose of pressure. The farthest zone I have currently is a run of 150' and then approx 150'

where the heads are. I have good pressure on this zone. I am off a well with a high velocity pump. Thanks