You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1810 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, July 8th 2013, 6:41pm

by Wet_Boots

First you check all the visible field wire connections, looking in valve boxes. A faulty connection isn't all that easy to locate like one would a broken wire, since there is continuity for a locating signal to travel from controller to valve.

Monday, July 8th 2013, 4:51pm

by shree (Guest)

How to detect a broken wire?

I have Hunter sprinkler system. Zone 7 voltage at the coil checks 11 volts instead of 24volts. It checks 24 at the controller. My guess I have a bad connection somewhere under ground. Is there a way to check and find the bad spot?