You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The first post

Wednesday, June 19th 2013, 1:33pm

by 4U2NVME

Installing New Irrigation System at House - Help Please.

Hello all,

I have been looking around the internet for a week or so looking for a good source to show me how to piece my pump and controllers and wiring together.

I am designing my system to flow about 35 GPM, I am on an irrigation system that provides in excess of 60GPM at a head of 15psi already.

I have a RedLion RLSP-200 2HP pump, will be running it at 220V
I purchased a Irritrol PC Controller ( http://www.sprinklerwarehouse.com/Irritrol-PC-Control-s/93.htm ).
I'm adding a pressure tank ( 5 - 10 gallon )
A Cycle stop valve (http://www.wellwaterproducts.com/categories/Cycle-Stop-Valve/ ) ( 1 - 50 GPM)
I also have a pressure switch 40 - 60 PSI
A Hunter pump relay start PSR-22 (http://www.sprinklerwarehouse.com/Hunter-Irrigation-Pump-Start-Relay-p/PSR-22.htm)

I am irrigating 2.5 acres of grass and trees, I am using a 2 inch main line and 1.5 inch hunter valves ( http://www.sprinklerwarehouse.com/Hunter-Sprinkler-Irrigation-Valve-p/ICV-151G.htm )

Do I need a one way valve to prevent pressure loss, or will the pressure tank prevent water to run back past my pump. I have 15psi of head coming to pump, I want to run my system at 50 PSI and maintain 50 PSI when the pump shuts down.

I am not sure what and all I need do I need all I have, if I am using a pressure switch, do I need the Hunter pump relay start attached to my Irritrol controller. What is the process for wiring all the electrical together?

Is there a way to protect my pump so that if they turn off the irrigation supply to repair something and not tell me, or my filter gets plugged that it will turn off if there is low or no flow for a short period of time?

Thanks for any help you can lend me.

Brad