You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 463 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Thursday, June 13th 2013, 8:22am

by Wet_Boots

You could have a field wiring failure. The multimeter check I recommend is for resistance.

Wednesday, June 12th 2013, 2:12pm

by yusufali

Get a multimeter and check the system wiring.


I did. It shows voltage going to all 6 zones even though only zone 1 or zone 2 is active. Same test using multimeter on my neighbors controller shows voltage only on the active zone.

Thanks.

Wednesday, June 12th 2013, 7:21am

by Wet_Boots

Get a multimeter and check the system wiring.

Tuesday, June 11th 2013, 11:37pm

by yusufali

No water on any zones

I have a hunter controller. About 15 years old. During the last scheduled run no water came out of any zones. The controller counted down fine. I have reset the controller without success. I have swapped the controller with a new one same results. I checked the wires at the controller; basically when a zone is active, all the wires have voltage. I compared that withy neighbor who has the exact controller and when his is running in one zone only that zone has voltage.

What does that mean? Is my controller bad? Or is there a problem on the wiring? I do not have any wires in the MV slot. Only AC and G, C and 1-6 have color coded wires.

Any help will be appreciated. Thanks.