You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1981 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Thursday, June 13th 2013, 1:15pm

by mrfixit

I haven't used the MP's a lot. Or any rotory nozzle. I recently experimented in a guys yard with low pressure and an odd installation job. Nothing covered right. I installed the MP's on part of the lawn and the Rainbird rotory nozzle on the other part of the lawn. The entire lawn's in direct sunlight.
Right off the bat the Rainbirds looked better. They have a nice spin to them and a nice pattern. Very pretty to look at.
The MP's turned super slow with tiny streams of water. I thought they were broken.
After a couple of weeks the Rainbird section was nice n green and the MP's had brown spots all over. So I went back and replaced 14 of the MP's with the Rainbirds. Everything's green now.
I beleive the MP's can run on less water than the Rainbirds but I haven't read the specs.
Rainbird Rotory Nozzle

Wednesday, June 12th 2013, 7:18pm

by electrifiedmale

60 psi at the pump, maybe higher (downhill) at the riser, but they have 30 psi pop-ups.
I'm not a sprinkler pro, so this is just a thought. Maybe the regulator in the 30 psi pop up body isn't regulating right and letting too much pressure through? Does it spin fairly fast right away when you replace a mp rotator or spin normal and gradually increase over time, or does it spin normal for however long and suddenly go crazy the next? How long is it taking them to fail after you install them?

It's easy enough to measure the pressure at the fast spinning heads to find out if there is a pressure problem with the body regulator. SW sells a fitting that connects to the pop up riser of the sprinkler body. the MP rotator screws into the top of the fitting. there is another port on the side of the fitting to connect a pressure gauge, so you can measure the pressure at the problematic sprinkler head. I got one recently and its nice to know what the pressure actually is at the sprinkler head if there is any question about it.

Other than maybe a pressure issue wearing them out, I really don't yet have enough experience with MP rotators to know what a reasonable life span of them would be while operating under reasonable conditions.

Wednesday, June 12th 2013, 11:51am

by MrMarkSH (Guest)

MP Rotators Failing

60 psi at the pump, maybe higher (downhill) at the riser, but they have 30 psi pop-ups.

Sunday, June 9th 2013, 9:48pm

by Wet_Boots

What kind of pressure are they getting? Can you throttle down a zone valve?

Sunday, June 9th 2013, 8:17pm

by MrMarkSH (Guest)

MP Rotators Failing

I know nothing lasts forever, but with 8 zones totaling over 90 heads, failing MP Rotators are driving me to the poorhouse. They seem to wear out -- the head gradually spins faster and faster until it's just putting out a mist.

Is there something better out there?