You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1869 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 6th 2013, 7:51pm

by Scott76

If the water is coming out somewhere other than the nozzle opening then the rotor or riser is bad. Start with the riser, as it's cheaper.

Monday, May 6th 2013, 12:25pm


Water overflowing out of side of rotor


I replaced a spray head that was in 1 of my zones with a 4 inch rotor to better cover the area. I see that this new rotor, however, has water gushing out of the side of the riser while functioning. It happens to be located at the end of a downward slopping pipe run.

Is the gushing water an idication of too much water pressure for that rotor? Do I ignore it?