You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 517 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, April 17th 2013, 5:56pm

by mrfixit

It sounds like pilot error to me. I don't know which Rainbird controller you have but you might be scheduling in two start times instead of one.
On most controllers station number two doesn't need it's own start time.
If station number 1 and 2 are running on the same days of the week and you want them to run in sequence then only one start time is needed.
If you want station number two to run at a different time of day than station number one then program it on the B program.

I know Rainbird has some newer controllers where each zone is given a start time. So if you want the sprinklers to run in sequence at 6 am, you'd give each zone a 6 am start time and they'll run in sequence.

Wednesday, April 17th 2013, 3:50pm

by Idonthaveone (Guest)

Rainbird station issue

I have a Rainbird controller that properly runs station 2 when run manually... however when I set the schedule and assign station 2 to a time, station 1 runs. Also, station 1 runs normally in both manual and scheduled modes.
If i immediately flip back and try it manually, station 2 runs, no problem.