You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 611 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Friday, January 18th 2013, 1:40pm

by Wet_Boots

In general, you do not want pressure losses in a system's main line, so you don't skimp on that point. Also, the flow of 30 gpm is beyond the usual operating range of one-inch zone valves, so for the sake of maximum economy, system flows would be kept to 20 gpm or less.

Thursday, January 17th 2013, 6:21pm

by valovic

redesign

I went back to rainbird and they redesigned it a bit. They now have the main lines and lateral lines as 1-1/4. I'll just stick with that

Sunday, January 13th 2013, 7:10am

by wsommariva

30 gpm? Good for you.

Saturday, January 12th 2013, 8:37pm

by Wet_Boots

I'll Rainbird one better and flatly state that 30 gpm is 1-1/2 inch territory, both for mainline and zone valves.

Saturday, January 12th 2013, 6:29pm

by valovic

1.25" sprinkler design but I want to drop to 1"

OK so I have been planning on instaling my own sprinkler system, and I'm just about to rent the trencher. I had rainbird design the system, and they did an OK job. I have to redesign a few things over. One question is - they would not design my system for a 1" line, they said with my flow and PSI that they had to size it for 1.25", but that I could reduce it after they designed it with no problem. I've got 50 psi and 30 gpm on right from the 1" main line. They have designed a zone to have 10 heads or the 5000 series per zone. They said it was not safe to design a residential system with 30 gpm on a 1" line. I don't understand why it is unsafe. Anyone see an issue with me putting 10 rotor heads on all 1" lines with my pressure and flow?
I can send the design if you want to see it.
valovic has attached the following file: