You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 678 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, November 20th 2012, 8:28pm

by mrfixit

Maybe you cut the wire to valve number 4 when you were digging.
Maybe it's just a coincidence that the valve stopped working at the same time you changed the head.
Make sure the wiring's ok and the valve's getting power from the controller.
Did you turn on and off the valve manually while you were working? Maybe you accidently disconnected a wire.
Did you turn off the flow control or the water to the valve?
Does it function manually?
That's a good start.

Tuesday, November 20th 2012, 4:17pm

by meredithwb

Replaced Sprinkler Head; Station Now Not Functioning

It's not like I've never replaced a sprinkler head before, but I don't get this one.

Last night, one sprinkler was shooting straight up in Station 4. Today, I dug around that head, twisted it off, and replaced it with a new one. That's it. Now the entire station won't run. I give up.

Anybody?

Thanks for any insight.