You are not logged in.

  • Login
  • Register

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, September 25th 2012, 9:58am

by Wet_Boots

If you want to save the installed nozzle to use later on, you might run the zone with the nozzle screw backed out, and let the water pressure blow it out of the head.

Monday, September 24th 2012, 2:40pm

by Curmudgeon10

Remove and Replace Nozzles in Hunter PGP Rotors

I know how one stalls these in a new head --- no problem. But how do you remove one that is already installed in order to put in a different nozzle? Yes, I can back out the set screw. But then it's difficult to see how to extract the embedded nozzle (without inserting something (what?) in the nozzle hole, if it's big enough and trying to pull it out).