You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 644 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Wednesday, October 24th 2012, 6:31pm

by Ertyrock (Guest)

interesting read

I am not sure where you are located but this site has some interesting articles on the topic.....
http://harriswatermainandsewers.com/news/article/what-is-a-water-line-tap-connection-wet-tap-connection-main-water-line-conn

Tuesday, July 24th 2012, 5:56pm

by Central Irrigation

PVC is not recommended for inside a house. Copper would be the proper way to do it. Or, T off with pex and run that to the exterior wall and then convert to copper.

Tuesday, July 24th 2012, 2:15pm

by wsommariva

Valves should be buried in valve boxes.

Blowout after the PVB if you use one generally. Or just a convenient place.

I think the pros like to use copper until it goes outside and then switch to pvc.

I tapped into pex in the basement. A few feet before it went outside I switched to pvc.

Tuesday, July 24th 2012, 12:25pm

by Luke1

Tapping into Water Main Questions

Hello,

I need help on how to tap into my water main that is in my basement for a new sprinkler system install. I have 1" PEX that I can tap from. Should I use 1" PEX then switch to 1" PVC right before the line goes outside? Also, where should my blow outs be for winterizing? Is it better to have the outside control valves buried? Thanks in advance for any advice you can give me!