You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 865 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Saturday, July 14th 2012, 7:51am

by wsommariva

What is your GPM at the rotors??????????

Check for debris under the heads

These heads are adjustable. Move the lower ring to adjust when water is flowing

Friday, July 13th 2012, 3:43pm

by dave_v (Guest)

I'm using 3/4 in, 100 psi coil poly.

Friday, July 13th 2012, 3:36pm

by GatorGuy

These are variable nozzles.
PSI counts but at some point GPM is more important.
Depending on how you have them set you use from 5.25 to 10.17 gallons per minute.
For a 3/4" PVC pipe you have either Class 200 or Schedule 40.
Class 200 allows for 10 gpm design volume.
Schedule 40 allows for 7 gpm design.
If you have a 3/4" sch 40 pipe it is possible you are overdrawing your supply.

Friday, July 13th 2012, 3:35pm

by dave_v (Guest)

After using a head loss calculator it looks like the 3/4 pipe is causing a head loss of about 9psi so I am down to 40psi at the rotor. May have to upgrade to 1" or larger pipe.

Friday, July 13th 2012, 2:38pm

by dave_v (Guest)

3 MP3000 90-210
1 MP3000 210-270

they are on a Hunter shrub adapter directly on a 4" inch fixed riser. The rotor itself is not opening all the way each time.

I did not expect 4 rotor on a 3/4 inch circuit to be a problem at 50 psi. The farthest rotor is about 50 ft from the valve where the pressure is measured. I don't have the needed fitting to measure the pressure at the rotor right now.

Thanks,
Dave

Friday, July 13th 2012, 2:25pm

by GatorGuy

All the symptoms of low pressure.
When you say "won't pop consistently" what do you mean? Are they directly on the riser or on a popup on the riser?
Which models/patterns?

Friday, July 13th 2012, 2:16pm

by dave_v (Guest)

Hunter MP rotors not working properly

Rotors not opening or rotating.

I just got my shipment of Hunter MP rotors. I attached four of them to shrub adapters on 4" risers. There are four rotors on the circuit of 3/4 plastic pipe. The water pressure at the valve is about 50 psi. When the valve opens two of the rotors appear to work properly (although I am disappointed with the radius). The other two just won't pop consistently and when the do they aren't rotating.

Any suggestions?

David