You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2192 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Thursday, June 21st 2012, 3:03pm

by GatorGuy

Controller shows “ERR” in display • Module wires not properly
connected to controller terminal. Check the connection between module and controller and
compare to wiring diagram in System Installation section of Owner’s Manual

Solar Sync module shows “ERR” • Connection between module and
sensor faulty
Check connection

If connections good check from stripped insulation.

Thursday, June 21st 2012, 2:23pm

by shawj1266


I just installed a SolarSync sensor to a Hunter PCC1200i controller and I get a Err message in the display. What would cause that? There is nothing in the manual about this and I followed the directions to a tee.