You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2418 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, June 5th 2012, 8:17am

by GatorGuy

Each zone only has a certain amount of water available, measured in gallons per minute.
You need to know this to decide how to set your nozzles.

Since you already have I-20s installed we'll assume you have enough pressure and flow.
In that case you have a couple of options.
First is look at the old ones and see what they have, match.
Second, measure from one head to another, assume you have a certain amount of pressure (say 50psi) and choose the nozzle that fits that distance. For example, at 50 psi nozzle # 3 will go about 38' (always figure the distance listed is maximum under ideal conditions.) The chart is located HERE
Finally, start with the low end nozzles on all of them, see how they work, change out if needed.
Knowing the psi would help a lot.

Monday, June 4th 2012, 6:01pm

by Bfish78 (Guest)

Hunter I-20 nozzle selection?

I'm about to replace some I-20 hunter heads (4 or 5 per zone) but I have no idea which nozzle to use? I got 12 nozzles with each head (4 low angle & 8 standard). Do I need to know the gpm or pressure? ......I don't have either.