You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2441 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 14th 2012, 3:48pm

by Wet_Boots

.75 gpm heads are nothing to design with for an entire system. The dollar savings on an install won't make up for poor system performance.

Monday, May 14th 2012, 9:24am

by bpa2323

Poly pipe size????

Hello, I am working on a system we have 8 gallons a minue with a pressure of around 35 psi +/- we have some long runs on some zones almost 200 feet on one and less on others. I am planning on 7-8 heads with .75 gpm in order to reduce the number of zones there are three zones as of now. Should I run all 1" poly or 1" poly to the valves and 3/4" poly for the runs? I want to make sure I have enough flow... any and all suggestions are welcom. Thanks