You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2442 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, May 13th 2012, 10:43am

by Wet_Boots

The obvious idea is that you replaced the wrong valve - you might do a resistance check of the zone wiring

Sunday, May 13th 2012, 10:02am

by Robbigz

Poor Automatic Water Pressure - One Zone only

I have low automatic water pressure in one zone only. When I activate the manual bleed screw, the pressure in that zone is fine. (Note) This was occuring on an existing brass valve. I replaced the valve and the problemhas remained.
Any ideas?