You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2463 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, April 23rd 2012, 1:30pm

by Wet_Boots

You can design a system to work with 6 gpm - I've done it before. You just need to use zone valves with flow controls. If the well water has any sand in it, you will also need to filter the water in the supply plumbing.

Monday, April 23rd 2012, 9:29am

by ktm250rider (Guest)

low flow rate design

I would like to install a sprinkler system but my well is only rated at 6.0 GPM. Well depth is 500 ft. When the well was drilled they hit water at roughly 350 but I went the extra 150 in the hopes of getting more capacity. Im looking to water just the front yard which is approximately 60 x 120 (7200 sqft). Currently, I can run 3 rotary sprinkers in line with a standard 1/2" garden hose connected to the spigot at the incoming water supply from the well. Total garden hose length is about 150ft and i get about a 40ft diameter water pattern.

Is it possible to run a sprinkler system with these parameters? Ive seen info where 8 gpm is minimum.