You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2689 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 7th 2007, 9:39am

by jmduke7

You could call a distributor in your area and swap the module. Try this first..... Take and power down the controller (turn off the breaker), unplug the module. wait a few minutes. Then reverse the process and pug the module back in, and power the controller back up. If that does not work do a master reset / clear on the controller. Sometimes there are glitches and you can only clear them with a shut down or master reset.

Best of luck!
<><

Monday, May 7th 2007, 9:09am

by davidl

Hunter Pro-C 1 Zone Not Shutting Off

I have one zone not shutting off. Even with the unit set to off that zone is getting 24 voltage. When I disconnected the wire the zone shuts down. The zone is number 3, on the module with the common wire, so I can't swap the modules to test. How can I tell if it is the module or the controller itself?

Thanks In Advance.
Dave