You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4501 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, September 22nd 2006, 7:50pm

by jmduke7

The only difference I am aware of is the color. But there are codes (at least in my area) against using anything other than standard white pvc (or violet for reclaimed water), for plumbing. The color is supposed to tell whom ever comes in contact with it, as to what is is being used for. (white plumbing / green sewer / grey electrical and etc..)

I do see what you are thinking, as for the gradual sweep of the ell as opposed to a standard pvc ell. I am just not sure there is enough difference (if any at all) to be of any advantage (probably cost more than it is worth). There is a way you can figure it out. All you will need is the amount of water going through the fitting and the overall length and then look up the friction loss for that amount of water through sch 40 pvc (won't be exact, because of the curvature of the fitting, but it would be close). A 1" ell has the equivalent friction loss of 2.25' of 1" sch 40 pvc pipe. ( )

Friday, September 22nd 2006, 5:53pm

by malibu jim

90 degree electrical pipe

I don't know if this has ever been discussed, what do you think of using sched 40 elect conduit on corners ? I know it's more expensive, 1 elbow and 2 connectors vs. 1 elbow. Would seem it would take a lot of friction out of the system. What is the difference between the white sched 40 used for sprinklers and the gray sched 40 used for elect conduit ?