You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3510 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Thursday, July 9th 2009, 9:18am

by Frankpc

Thanks WB, per my other message,

You've made me realize I need to abandon the idea of mounting the RPZ indoors. However, the only thing I have already purchased is the RPZ. I would appreciate your advice in the other thread.



Thursday, July 9th 2009, 8:29am

by Wet_Boots

A failed RPZ can dump full flow, just as if you sawed a pipe in two. You only locate them indoors where there is a good floor drain, and hopefully an alarm on the RPZ itself. If the house is highest, you use the PVB, and bring your plumbing out above grade, so all the drainage can be outdoors.

Wednesday, July 8th 2009, 10:10am

by Frankpc

House is 60 feet from street.

The house is the highest point on the property, which is 70' x 140'. The point at which the RPZ would be in the basement would be below the sprinkler heads in the front yard and above the sprinklers in the backyard since the house has a walk out basement.

Could I attach a drain hose to the RPZ such that the water expelled would be taken directly to a drain in the basement? Do you have any idea how much water will be expelled?



Tuesday, July 7th 2009, 7:24pm

by Wet_Boots

How far is the house from the street? Is the house the highest elevation on the property? how large is the property?
High pressures and long supply lines lead to water hammer. Water hammer will cause your proposed RPZ to squirt water, so you will not be installing it indoors.

Monday, July 6th 2009, 5:14pm

by Frankpc

Regulator needed if 117 psi static?

I measured water pressure and flow rate in my basement. The line coming into the basement is 3/4" copper.

The measurements were made from a hose bib located just after the main shutoff. Hose bib is tee'd to the 3/4" line via a short 1/2" copper nipple.

I measured 117 psi with no water running. Then I measured 13 gpm out of the hose bib with a 7' section of 7/16" inside diameter rubber hose attached.

I have two questions...

Since the hose bib and hose is smaller than the 3/4" copper pipe, should I expect a flow rate of 13 gpm when I tee directly into the 3/4" line or will it be higher?

Do I need to install a pressure reducing valve for the sprinkler system to drop it something around 80 psi? Also read there is "straight valve with cross handle" that serves to reduce pressure. Is that something to try? It would seem the downside is that it reduces pressure but doesn't regulate.

Thanks for the help.